Foundry Networks IRONPOINT 250 Manual de usuario descargar pdf (Pagina 40)

Foundry IronPoint 250 Installation Guide

Connecting to a Switch, Hub, PC, or Server

1. Attach one end of a twisted-pair cable segment to the network device’s RJ-45 connector.

Figure 5-1. Connecting to a Network Device

2. Attach the other end of the cable segment to the Ethernet port on the access point.

Note: Make sure the twisted pair cable does not exceed 100 meters (328 ft) in length.

3. As the connection is made, the access point’s Link LED should light indicating a valid network

connection. If the Link LED fails to light, see Appendix A for troubleshooting information.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 63 64

Sin comentarios

Foundry Networks IRONPOINT 250 Manual de usuario Pagina 40